 |
Heat press, mug press, cup press, Troy mugger, heat resistant gloves |
| Products Link to us Blogs Techies Contact Site Map |
|
Office 406-333-0330 |
Cell 208-304-9359 USA only |
|
|
|
Heat press, mug press, cup press, Troy mugger, heat resistant gloves |
| Products Link to us Blogs Techies Contact Site Map |
|
Office 406-333-0330 |
Cell 208-304-9359 USA only |
|
|
HOME
Refillable Ink Cartridges
|
|
Digital Mug Press The Troy Mugger Full wrap-around, handle to handle, top-to-bottom printing. Press images up to 4" high, and as close as 1/4" from the handle, depending on the mug size. Allows for full bleed transfers on even the most demanding mugs. Fully adjustable, accommodating different mug and cup sizes. This mug press adjusts for less than perfectly straight mugs. Temperature preset to 400*F. Automatic digital timer. Heats to full temperature in 270 seconds. Adapts instantly for most mugs on the market. Ultra soft heater liner for accommodating inconsistent mugs. End-of-cycle alarm. 3 month warranty on the heating blanket. 12 month warranty on entire press. Extremely light weight and portable. Ideally suited for Flea Marketing or on the road tours where weight and size are crucial. Electrical: 120 Volt/250 Watts/ 2.2 Amps. Weight 8 Lbs. Dimensions 12" Long x 6" Deep x 6" high. |
|
|
1 pair of Heat Resistant Gloves $19.95 |
| Tile pressing tips The BEST method for pressing tile is proven to be FACE DOWN, with thick Nomex and without 1/8" green rubber. The green heat conductive rubber does not wrap around the radius of the tile as well, it looses heat when placed on top of the tile, it is extremely expensive and it has a short life-span. The "best-by-far" tile printing method we have found with 100's of tile printing heat press customers as well as the major manufacturers is as follows: 1. Use 1/2" white Nomex felt only for tile pressing. 2. Lay Nomex on top of black padding of swing-away heat press. 3. Lay cover sheet of plain paper on felt. 4. Place transfer paper face up (ink-up) on top of cover sheet. 5. Place tiles face down onto transfer paper. 6. Lay additional cover sheet over back of tiles to protect heat platen Teflon coating (optional). 7. Heavy pressure, 415°F, 6-12 mins. (time varies based on size of tile, and number of tiles pressed at once) |
|
Shipping Please email us for shipping fees outside the USA.  Payment We accept |
 |
 |
 |
 |
 |
 |
| All merchandise returns
must be accompanied with an RMA number. Neither the seller nor the manufacturer shall be liable for any injury, direct or consequential, arising out of the use of, or inability to use, these products. You as the purchaser take full responsibility for the use of the purchased product. |
|
|
|
Avoid painful |
